Due to the different shapes of electronic aerosolizers on the market, packaging methods generally fall into two categories:Disposable Vape, Electronic Cigarettes, vape
1. For electronic aerosolizers that require uniform orientation, manual discharge and machine packaging are required;
2. For the electronic aerosolizer without orientation, the machine fully automatic discharge packaging.
The electronic aerosolized aluminum-plastic blister packaging machine is made of PVC and aluminum foil as the main packaging materials for packaging various types of electronic cigarettes, electronic cigarette cores and electronic cigarettes.
(Consult custom packaging machine, you can send the package to our factory first. Our factory technicians provide mold design drawings, confirm the drawings and then customize the machine)
Electronic aerosol core aluminum plastic blister packaging machine workflow
1. Forming (up and down heating) - heat sealing (upper heating) - coding - indentation (micro heating) - cutting knife - forming output finished product
Blister packaging machine ? Operating procedures:
1. The green indicator light is on, and the heating switch is formed up and down and heat-sealed respectively to open the operating position. The temperature controller controls the forming temperature, generally preset to 100oC, the second temperature controller controls the heat seal, and the temperature preset is 130oC~140oC. Upper and lower molding and heat sealing temperature controller preset temperature; specific as appropriate.
2, put down the pressure block on the feeding roller, the temperature of the forming heating plate is in place, and then open the main machine, the plastic PVC is first formed, the forming blister is in conformity with the hole position of the heat sealing mold, pay attention to the heat sealing mold cylinder and put down the heat sealing mold to press the aluminum foil. The aluminum foil will drive to the punch.
Observe whether the plastic (referred to as the new PVC surface of the machine board) is tilted left and right. If there is a bias, the direction of the pressure roller should be adjusted.
3. If the aluminum foil is tilted left and right, the adjustable turning roller seat hand wheel is adjusted. If the front and rear deviations are adjustable, the box moves.
4. After the heat seal is normal, open the feeder switch and the gate properly, so that the medicine (tablet capsule, grain clothing) enters the feeding room in an appropriate amount. If there is a small amount of cylinder material, it can be manually filled. If the medicine is brought into the heat, When sealing the mold, it will seriously affect the synchronization. Therefore, when the aluminum foil is sealed, it should be stuck on the mold and it should be stopped.
5, due to increased drug weight, aluminum foil tension and machine temperature gradually varying degrees, may cause molding and heat sealing is not synchronized, leading or lagging, first check whether plastic PVC and aluminum foil have a negative separation, and then can be adjusted by fine adjustment mechanism on the machine. The fine adjustment mechanism is adjusted backwards or the front and back of the cabinet as the mold is turned backwards. Therefore, it should be placed in the neutral position before starting, so that it can be moved forwards and backwards. It can also be adjusted by moving the front box. After correct movement, the section has to wait for more than ten editions to be correct, so when it is not finished, don’t mess Transfer to adjust.
6, plastic, aluminum foil heat-sealing quality (bonding uniform and firm) by temperature or pressure, the relief of the screen plate to see, if there is a bad heat seal, generally suitable temperature, pressure is slightly lower, the regulator is positive temperature, Zui Adjust the screw pressure afterwards.
7, punching the bias, cut the layout offset. When the machine stops, the hand is moved to the box, and the mode shift can be adjusted.
8, in the daily operation knowledge, for the operation of the work must know the structure of the machine, the wheel of the cam drive ejector,
Up and down stroke, the position of the upper cover template is fixed, and the blister is in a bad state. Pay attention to the forming die or heat sealing to the top dead center, and fix the column nut tightly. If it is not careful, it will be easy to malfunction, and the roller needle pinching phenomenon of the plunger pressing .
